Features:

• Boosted and Naturally Aspirated Applications
• 300 PSI UHO (Ultra High Output) Pump
• 3 Quart Reservoir
• All Tubing Necessary for Installation
• MAFU Progressive Controller for Use With All MAF / MAP Sensors
• Pig Tail Harness
• Level Sensor Upgrade
• 1 Nozzle Holder / Check Valve Combo
• 2 Hyper-Sonic Nozzles
• Installation Hardware
• Snow Performance Running S Decal
• Snow Performance 1-Year Warranty
• Difference between stage 1, stage 2, and stage 3?
• Accessories / Upgrades Click Here

Stage 1 Boost Cooler

The Stage 1 Boost Cooler uses an adjustable boost switch to inject a fixed amount of water-methanol into the system until the boost drops below the switch set point.

Note: For applications above 1,000 HP please call so we can order you custom injectors.

Race gas quality fuel on pump gas! Increase your pump gas octane by 25 points and make more power efficiently with a cooler running motor! The Snow Performance Stage 1 Boost Cooler water methanol injection kit is available for all forced induction applications (Supercharged/Turbocharged) and uses a adjustable boost switch to inject a fixed amount of water methanol into the system until boost goes below the switch set point. Proven to deliver 30-70 HP increases to all forced induction applications! This makes it a good choice for low to medium boost set ups, drag race applications, and vehicles with a positive displacement supercharger (Roots/Twinscrew) looking for an octane enhancement and cooler intake charge. Activation can also be set up through any other user chosen switch, such as a full throttle switch, nitrous switch, etc.

This kit utilizes the only OEM approved water methanol injection pump on the market with proprietary heat flange, twin seals, and custom motor winding to run cooler and longer than the competition. The Extreme Environment 300 PSI UHO Pump is designed to be in the elements with O-Ring connections that are then sealed and potted to ensure no moisture can enter the pump internals. Compare this to pumps that us a pump "sleeve". These sleeves will keep moisture around the pump unit leading to corrosion as well as trap heat to greatly decrease pump life. The Stage 1 comes standard with 100% methanol resistant components using stainless steel, nickel plating, EPDM, and hard anodizing to ensure years of continued use. Tie that in with new Snow Performance ACU-SEAL compression fittings for guaranteed leak free operation even when using 100% methanol. F or a extremely robust, reliable water methanol injection experience that won't break the bank look no further than the Snow Performance Stage 1 Boost Cooler.